Cisco 2811 ROUTER 2FE 1NME 4HWIC 2PVDM 2AIM IP BASE WITH A/C POWER SUPPLY Specification Guide
Corporate Headquarters:
© 2005 Cisco Systems, Inc. All rights reserved.
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Chassis Installation Procedures for Cisco 2800
Series Routers
Series Routers
This document describes how to install your Cisco 2800 series integrated services router on a desktop
or in a rack. It includes the following sections:
or in a rack. It includes the following sections:
•
•
•
•
Note
To see translations of the warnings that appear in this publication, see the
document that
accompanied this device.
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Statement 1030
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Installing Modules and Interface Cards
Cisco routers are normally shipped with network modules, high-speed WAN interface cards (HWICs),
and voice interface cards (VICs) already installed. If you need to remove or install any of these items,
see the following product installation documents, either online or shipped with the product:
and voice interface cards (VICs) already installed. If you need to remove or install any of these items,
see the following product installation documents, either online or shipped with the product:
For Network Modules
•