Cisco 2811 ROUTER 2FE 1NME 4HWIC 2PVDM 2AIM IP BASE WITH A/C POWER SUPPLY Specification Guide

To display and verify the hardware features, enter the following commands:

show version—Displays the system hardware version; the installed software version; the names and 
sources of configuration files; the boot images; and the amount of installed DRAM, NVRAM, and 
flash memory.

show diag—Lists and displays diagnostic information about the installed controllers, interface 
processors, and port adapters; typical examples are network modules, interface cards (VICs, WICs, 
HWICs), and advanced integration modules (AIMs).

This section covers the following topics:

You can configure your router by using one of the following tools:

Cisco Router and Security Device Manager—See the 

.

Setup command facility—See the 

.

Command-line interface (CLI)—See the 

.

AUX/
PWR

Green

IP phone power operating normally (if installed), or

Cisco Redundant Power System (RPS) operating normally (if installed)

Amber

IP phone power fault (if installed), or

Cisco Redundant Power System (RPS) fault (if installed)

Off

IP phone power and Cisco RPS are not installed

SYS 
ACT

Blinking green or solid green

Packet transfers are occurring or internal monitoring activities are 
occurring

Off

No packet transfers are occurring

CF

Blinking green or solid green

Flash memory is being accessed; do not eject the CompactFlash memory 
card

Off

Flash memory is not being accessed; okay to eject the CompactFlash 
memory card