Cisco 2811 ROUTER 2FE 1NME 4HWIC 2PVDM 2AIM IP BASE WITH A/C POWER SUPPLY Specification Guide

If you need help with the interface and port numbering, refer to the 

 section of 

the “

online document.

The following messages appear at the end of the startup sequence:

yourname con0 is now available

Press RETURN to get started.

For instructions on configuring your router by using SDM, refer to the 

 that shipped with your router. If the messages above do not appear, 

SDM and the

 

 

were not shipped 

with your router. If you want to use SDM, you can download the latest version of SDM and instructions 
for installing it on your router from the following location:

http://www.cisco.com/pcgi-bin/tablebuild.pl/sdm

To obtain the SDM quick start guide, SDM release notes, and other SDM documentation, go to 
www.cisco.com/go/sdm and click the Technical Documentation link.

For help with interface and port numbering, refer to the 

 section of the “

of Cisco 2800 Series Routers” 

online document.

This section shows how to use the setup command facility to configure a hostname for the router, set 
passwords, and configure an interface for communication with the management network. If you see the 
following messages at the end of the startup sequence, the setup command facility has been invoked 
automatically:

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Would you like to enter the initial configuration dialog? [yes/no]:

The setup command facility prompts you for basic information about your router and network, and it 
creates an initial configuration file. After the configuration file has been created, you can use the CLI or 
Cisco Router and Security Device Manager to perform additional configuration. 

The prompts in the setup command facility vary, depending on your router model, the installed interface 
modules, and the software image. The following example and the user entries (in 

) are shown as 

examples only.

For a description of the interface numbering, refer to the 

 section of the 

“

online document.

If you make a mistake while using the setup command facility, you can exit and run the setup facility 
again. Press Ctrl-c, and type setup at the privileged EXEC mode prompt (

Router#

).