Nortel 8005 AC POWER SUPPLY 100V/240V 1140W/1462W Specification Guide
Chapter 2 Installing power supplies 39
Installing an AC Power Supply in an Ethernet Routing Switch 8000 Series Chassis
Figure 20 AC power supply power switch on: 8006 and 8010 chassis
Figure 21 AC power supply power switch on: 8003 chassis
Removing the AC power supply
Note: Due to the N + 1 power system architecture, if your chassis
contains two or three power supplies, Nortel recommends that you turn
on the power supplies simultaneously. If you wait longer to turn on the
supplies, the power supply(s) shut off within 7 seconds. To correct this
condition, turn off the power supplies for a short period of time, and then
turn on the power supplies again simultaneously.
contains two or three power supplies, Nortel recommends that you turn
on the power supplies simultaneously. If you wait longer to turn on the
supplies, the power supply(s) shut off within 7 seconds. To correct this
condition, turn off the power supplies for a short period of time, and then
turn on the power supplies again simultaneously.
Danger: Due to high-energy hazards greater than 240 VA, only
qualified service personnel are permitted to install and replace Ethernet
Routing Switch 8600 components.
qualified service personnel are permitted to install and replace Ethernet
Routing Switch 8600 components.
8964FA
10244FA