Cisco CATALYST 6509E 9 SLOT 15U CHASSIS NO POWER SUPPLY NO FAN TRAY Specification Guide
3-3
Catalyst 6500 Series Switches Installation Guide
OL-5781-04
Chapter 3 Installing the Switch
Installing the Rack-Mount Kit
Installing the Rack-Mount Kit
This section describes how to install the rack-mount kit. The kit contains a shelf bracket and crossbar
assembly that attaches directly to the rack.
assembly that attaches directly to the rack.
The Catalyst 6500 series switch chassis also have L brackets that are used to secure the chassis to the
rack. Normally, the Catalyst 6500 series switch chassis are shipped with the L brackets installed. In
instances in which the chassis are not shipped with the L brackets installed, we have included L bracket
installation procedures in this section.
rack. Normally, the Catalyst 6500 series switch chassis are shipped with the L brackets installed. In
instances in which the chassis are not shipped with the L brackets installed, we have included L bracket
installation procedures in this section.
Open the rack-mount kit, and use the checklist in
to verify that all parts are included.
Rack-Mounting Guidelines
Before rack-mounting the switch, ensure that the equipment rack complies with the following
guidelines:
guidelines:
•
The width of the rack, measured between the two front mounting strips or rails, must be 17.75 inches
(45.09 cm).
(45.09 cm).
•
The depth of the rack, measured between the front and rear mounting strips, must be at least
19.25 inches (48.9 cm).
19.25 inches (48.9 cm).
Note
All of the Catalyst 6500 series switch chassis are designed to install in standard 19-inch racks.
Table 3-1
Rack-Mount Kit Contents Checklist
Part Description
Received
2 L brackets
1
1.
The Catalyst 6500 series switch chassis are normally shipped with the
L brackets installed.
L brackets installed.
M3 Phillips countersunk-head screws
M4 Phillips countersunk-head screws
2
2.
The M4 Phillips countersunk-head screws are included only in the
accessory kits for the Catalyst 6509-NEB and Catalyst 6513 switch
chassis. The M4 screws are for use with those two chassis only.
accessory kits for the Catalyst 6509-NEB and Catalyst 6513 switch
chassis. The M4 screws are for use with those two chassis only.
12-24 x 3/4-inch Phillips binder-head screws
10-32 x 3/4-inch Phillips binder-head screws
2 Shelf brackets
1 Crossbar bracket
M3 Phillips pan-head screws