Cisco CATALYST 6509E 9 SLOT 15U CHASSIS NO POWER SUPPLY NO FAN TRAY Specification Guide

4-10

Catalyst 6500 Series Switches Installation Guide

OL-5781-04

Chapter 4 Removal and Replacement Procedures

Removing and Installing the AC-Input Power Supplies

Removing the 1000 W, 1300 W, 2500 W, 3000 W, 4000 W, and 6000 W AC-Input Power Supplies

Warning

Hazardous voltage or energy is present on the backplane when the system is operating. Use caution
when servicing. Statement 1034

To remove an AC-input power supply, follow these steps:

Step 1

Turn the power switch to the Off (0) position on the power supply that you are removing.
(See

Figure 4-6

.) Turning the power switch off also disengages a pawl that unlocks the power supply

from the chassis.

Step 2

Disconnect the power cord from the power source.

Step 3

Loosen the screw on the cable retention device, and disconnect the power cord from the power supply
being removed.

Note

The AC power cord for the 4000 W power supply is hard wired to the power supply and cannot
be removed.

Step 4

Loosen the captive installation screw. (See

Figure 4-6

Caution

Use both hands to install and remove power supplies. Catalyst 6500 series AC-input power supplies
weigh between 14.5 pounds (6.58 kg) and 29.0 pounds (13.15 kg).

Figure 4-6

AC-Input Power Supply Front Panel

Step 5

Grasp the power supply handle with one hand, and slide the power supply part of the way out of the
chassis. Place your other hand underneath the power supply, as shown in

Figure 4-7

, and slide the power

supply completely out of the chassis.

Step 6

If the power supply bay is to remain empty, install a blank faceplate (Cisco part number 700-03104-01)
over the opening, and secure it with the captive installation screw.

Power
switch

Cable

retention

device

AC power

connection

INPUT

FAN

OUTPUT

FAIL

Captive installation

screw

Status LEDs

16029