Cisco CATALYST 5000 ROUTING SWITCH MODULE Specification Guide
Route Switch Module (WS-X5302)
Catalyst 5000 Family Module Installation Guide
7-2
The RSM front panel (Figure 7-1) has the following features:
•
PCMCIA slots—The PCMCIA slots are for additional system Flash PC card memory.
You can use this Flash PC card memory to store and run IOS images or as a file server
for other routers to access as clients.
You can use this Flash PC card memory to store and run IOS images or as a file server
for other routers to access as clients.
•
Reset button—The Reset button causes a nonmaskable interrupt (NMI) and places the
RSM in ROM monitor mode. (Use the Catalyst 5000 family switch reset command to
reset the RSM hardware.)
RSM in ROM monitor mode. (Use the Catalyst 5000 family switch reset command to
reset the RSM hardware.)
Note
Use a paper clip or other small, pointed object to access the Reset button.
•
AUX and console ports—The AUX port allows you to connect to a modem for remote
access to the RSM. The console port allows you to connect a terminal to the RSM for
configuration and monitoring.
access to the RSM. The console port allows you to connect a terminal to the RSM for
configuration and monitoring.
Figure 7-1
RSM (WS-X5302) Front Panel
The RSM LEDs are described in Table 7-1.
Table 7-1
RSM (WS-X5302) Status LED Descriptions
LED
State
Description
STATUS
Indicates a series of self-tests and diagnostic tests.
Green
All the tests pass.
Red
A test other than an individual port test failed.
Orange
System boot, self-test diagnostics running, or the module is
disabled.
disabled.
TX
CHANNEL 1
AUX
CONSOLE
RX
TX
CHANNEL 0
RX
SLOT 1
RESET
PCMCIA
SLOT 0
CPU HALT
PCMICA
EJECT
STATUS
ROUTE SWITCH MODULE
ENABLED
H10365