Cisco 7000 SERIES PA 8 PORT T1 MC ADAPTER WITH CSU DSU Specification Guide
1-9
Multichannel DS1/PRI Port Adapter Installation and Configuration
OL-3525-03
Chapter 1 Overview
Port Adapter Locations on the Supported Platforms
•
•
Catalyst RSM/VIP2 Slot Numbering
The Catalyst RSM/VIP2 can be installed in any slot except the top slots, which contain the supervisor
engines. The multichannel DS1/PRI port adapter can be installed into either port adapter slot 0 or slot 1
on a Catalyst RSM/VIP2.
engines. The multichannel DS1/PRI port adapter can be installed into either port adapter slot 0 or slot 1
on a Catalyst RSM/VIP2.
shows a Catalyst RSM/VIP2 with two port adapters installed.
Note
The Catalyst 5500 switch has 13 slots. Slot 1 is reserved for the supervisor engine. If a redundant
supervisor engine is used, it would go in slot 2; otherwise, slot 2 can be used for other modules. Slot 13
is a dedicated slot, reserved for the ATM switch processor (ASP) module. Refer to the Catalyst 5000
Series Route Switch Module Installation and Configuration Note for any additional slot restrictions for
the Catalyst RSM/VIP2.
supervisor engine is used, it would go in slot 2; otherwise, slot 2 can be used for other modules. Slot 13
is a dedicated slot, reserved for the ATM switch processor (ASP) module. Refer to the Catalyst 5000
Series Route Switch Module Installation and Configuration Note for any additional slot restrictions for
the Catalyst RSM/VIP2.
Figure 1-8
Catalyst 5000 Family Switch with Port Adapters Installed on Catalyst RSM/VIP2
Catalyst 6000 Family FlexWAN Module Slot Numbering
The Catalyst 6000 family switches can be installed in any slot except slot 1, which is reserved for the
supervisor engine. The multichannel DS1/PRI port adapter can be installed into either port adapter bay
0 or bay 1 on a Catalyst 6000 family switch.
supervisor engine. The multichannel DS1/PRI port adapter can be installed into either port adapter bay
0 or bay 1 on a Catalyst 6000 family switch.
shows a FlexWAN module with
two blank port adapters installed.
Note
Slot 1 is reserved for the supervisor engine. If a redundant supervisor engine is used, it would go in slot
2; otherwise, slot 2 can be used for other modules.
2; otherwise, slot 2 can be used for other modules.
27924
UTP
TX
H
AN
N
EL
1
AU
X
O
N
SO
LE
R
X
TX
H
AN
N
EL
0
R
X
SL
O
T 1
R
ES
ET
PC
M
IA
SL
O
T 0
PU
H
AL
T
PC
M
IC
A
EJ
EC
T
ST
AT
U
S
ROUTE SWITCH MODULE
EN
AB
LE
D
VIP2
Route Switch Module