Cisco 3640 4 SLOT ROUTER Specification Guide

Open a web browser on the PC, and enter the SDM URL, using the new IP address that you gave the LAN interface:

https://new-IP-address/flash/sdm.shtml

https://172.16.30.1/flash/sdm.shtml.

Step 10 Enter the username and password that you specified in Step 6 above.

Step 11 When the SDM System Overview window appears, you can use the wizard buttons on the left side of the window to

configure other features. Buttons are provided for LAN, WAN, firewall, and VPN configurations.

For more information about SDM, refer to the Cisco Router and Security Device Manager Troubleshooting Guide at the
following URL:

http://www.cisco.com/go/sdm

This section shows how to use the setup command facility to configure a host name for the router, set passwords, and configure
an interface for communication with the management network. If you see the following messages at the end of the startup
sequence, the setup command facility has been invoked automatically:

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Would you like to enter the initial configuration dialog? [yes/no]:

The setup command facility prompts you for basic information about your router and network, and it creates an initial
configuration file.The prompts vary, depending on your router model, the installed interface modules, and the software image.
The following example and the user entries (in

) are shown as examples only.

If you make a mistake while using the setup command facility, you can exit and run the setup command facility again.
Press Ctrl-C, and enter setup at the enable mode prompt (

3600#

).

88669

Example static
or dynamic IP address:
172.16.30.2/255.255.255.0

Crossover cable

Example configured IP address:

172.16.30.1/255.255.255.0

172.16.30.0 subnet