Cisco CATALYST 5500 9 PORT GIGABIT ETHERNET SWITCH MODULE Specification Guide
C H A P T E R
Switching Module Installation 3-1
3
Switching Module Installation
This chapter describes how to install and configure switching modules in your
Catalyst 5000 family switch and consists of these sections:
Catalyst 5000 family switch and consists of these sections:
•
•
•
•
Warning
Before you install, operate, or service the system, read the Site
Preparation and Safety Guide. This guide contains important safety information
you should know before working with the system.
you should know before working with the system.
Note
Before installing switch modules, you must install the Catalyst 5000 family switch
chassis and supervisor engine modules. For information on installing the switch chassis,
refer to the Catalyst 5000 Family Installation Guide. For information on installing the
supervisor engine modules, refer to the Catalyst 5000 Family Supervisor Engine
Installation Guide.
refer to the Catalyst 5000 Family Installation Guide. For information on installing the
supervisor engine modules, refer to the Catalyst 5000 Family Supervisor Engine
Installation Guide.
These tools are required to install switching modules in the Catalyst 5000 family switches:
•
Number 1 and number 2 Phillips screwdrivers for the captive installation screws on most
modules
modules
•
3/16-inch flat-blade screwdriver for the captive installation screws on some modules
•
Wrist strap or other grounding device