Pioneer AVIC-7201NEX Package Owner's Manual

Page of 203
PIONEER CORPORATION
1-1, Shin-ogura, Saiwai-ku, Kawasaki-shi, Kanagawa 212-0031, JAPAN
PIONEER ELECTRONICS (USA) INC.
P.O. Box 1540, Long Beach, California 90801-1540, U.S.A.
TEL: (800) 421-1404
PIONEER EUROPE NV
Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium/Belgique
TEL: (0) 3/570.05.11
PIONEER ELECTRONICS ASIACENTRE PTE. LTD.
253 Alexandra Road, #04-01, Singapore 159936
TEL: 65-6472-7555
PIONEER ELECTRONICS AUSTRALIA PTY. LTD.
5 Arco Lane, Heatherton, Victoria, 3202 Australia
TEL: (03) 9586-6300
PIONEER ELECTRONICS OF CANADA, INC.
340 Ferrier Street, Unit 2, Markham, Ontario L3R 2Z5, Canada
TEL: 1-877-283-5901
TEL: 905-479-4411
PIONEER ELECTRONICS DE MEXICO S.A. de C.V.
Blvd. Manuel Avila Camacho 138 10 piso
Col. Lomas de Chapultepec, Mexico, D.F. 11000
TEL: 52-55-9178-4270, Fax: 52-55-5202-3714
© 2015 PIONEER CORPORATION.  
All rights reserved.
© 2015 PIONEER CORPORATION.   
Tous droits de reproduction et de traduction 
réservés.
Printed in Japan 
Imprimé en Japon
<CJ-E09S08R> EL
< KFWZ15D >
Owner’s Manual
Mode d’emploi
UNIVERSAL REAR-VIEW CAMERA
CAMERA DE RECUL UNIVERSELLE
ND-BC8
1 Glass surface
2  Make sure it doesn’t touch the wiper
3  Install on the center part
Fig. 1
Abb. 1
A  Rear view camera × 1
B  RCA power supply cable × 1
C  Hexagon wrench × 1
E Waterproof
 
pad × 1
D  Clamp × 6
F Double-sided 
tape × 1
Fig. 4
Abb. 4
Fig. 8
Abb. 8
Fig. 6
Abb. 6
2  Bumper or rear edge of car
1 Camera
 stand
Fig. 2
Abb. 2
Fig. 3
Abb. 3
This device complies with part 15 of the FCC 
Rules. 
Operation is subject to the following two 
conditions:  
(1) This device may not cause harmful interference, 
and (2) this device must accept any interference 
received, including interference that may cause 
undesired operation.
Information to User
Alteration or modifications carried out without 
appropriate authorization may invalidate the user’s 
right to operate the equipment.
Note:
This equipment has been tested and found to comply 
with the limits for a Class B digital device, pursuant 
to Part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against 
harmful interference in a residential installation. 
This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful 
interference to radio communications. However, there 
is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause 
harmful interference to radio or television reception, 
which can be determined by turning the equipment 
off and on, the user is encouraged to try to correct 
the interference by one or more of the following 
measures:
• Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and 
receiver.
•  Connect the equipment into an outlet on a circuit 
different from that to which the receiver is 
connected.
• Consult the dealer or an experienced radio/TV 
technician for help.
 
If you want to dispose this product, do not 
mix it with general household waste. There 
is a separate collection system for used elec-
tronic products in accordance with legisla-
tion that requires proper treatment, recovery 
and recycling.
Private households in the member states of the EU, 
in Switzerland and Norway may return their used 
electronic products free of charge to designated col-
lection facilities or to a retailer (if you purchase a 
similar new one). For countries not mentioned above, 
please contact your local authorities for the correct 
method of disposal. By doing so you will ensure that 
your disposed product undergoes the necessary treat-
ment, recovery and recycling and thus prevent poten-
tial negative effects on the environment and human 
health.
WARNING:
This product contains chemicals known to the State 
of California and other governmental entities to cause 
cancer and birth defects or other reproductive harm. 
Wash hands after handling.
IMPORTANT  
SAFEGUARDS
•  Installation and wiring of this product require spe-
cialist skill and experience. To assure your safety, 
please request a specialist technician to install the 
unit.
•  Do not attempt to heat the surface of the camera 
lens or camera lens itself with a lighter and so on 
when they have become frozen. This can cause a 
malfunction.
•  This product is a rear view camera for checking 
the view at the rear of a car.
  A rear view camera is a camera that provides sym-
metrical images in the same way as rear and side 
view mirrors.
•  Connection to a TV with an RCA video input is 
possible, but confirm whether the TV you use has 
a reverse gear connection function.
•  This product is designed to supplement the driver’s 
rear view, but the camera images do not show all 
dangers and obstacles. Be sure to look behind you 
when reversing to confirm the view.
•  This product features a wide-angle lens, so the 
near view is wide and the far view is narrow, 
which may create a false sense of distance. Be 
sure to look behind you when reversing to confirm 
the view.
•  Do not wash your car with an automatic car wash 
or high-pressure water as it may result in water 
entering the camera or the camera falling off.
• Check camera stand installation before driving.
– Are the screws loose?
–  Is the camera stand firmly secured?
–  If the rear view camera comes loose while you 
are driving it may cause an accident.
•  This product by itself does not display guidelines.
6  Be sure not to hide any part of the characters 
on the license plate when attaching the cam-
era.
Fig.5
Abb. 5
00-00
Fig. 7
Abb. 7
2 Top
3 Mark
4 Bottom
5  Make sure to install the rear view camera so that 
the mark is located on top of the camera.
1 Hexagon wrench
approx. 45 º