Sony WX-850BT Owner's Manual
32
GB
Notes on installing the connection cable RC-SR1 (not
supplied)
supplied)
Refer to the support sites on the back cover for
details, then connect each lead properly to the
appropriate leads. Making an improper connection
may damage the unit.
appropriate leads. Making an improper connection
may damage the unit.
Depending on the type of car, be sure to insulate the
unused leads with electrical tape for safety.
Do not connect this cable when the steering wheel
remote control is not used.
Consulting the dealer or an experienced technician
for help is recommended.
When using the wired remote control
1
To enable the wired remote control, set [STR
CONTROL] in [SET STEERING] to [PRESET] (page 18).
CONTROL] in [SET STEERING] to [PRESET] (page 18).
Installation
Before installing this unit, remove the screw and
box on the back of the unit. Do not use the previous
parts you removed when installing the unit.
box on the back of the unit. Do not use the previous
parts you removed when installing the unit.
When mounting in a Japanese car, see “Mounting
the unit in a Japanese car” (page 32).
the unit in a Japanese car” (page 32).
Mounting the unit with an installation kit
(not supplied)
(not supplied)
You can use a commercially available double DIN
installation kit. Choose an installation kit with the
following panel frame size.
Larger than 172 × 97 mm (6
installation kit. Choose an installation kit with the
following panel frame size.
Larger than 172 × 97 mm (6
7
/
8
× 3
7
/
8
in) (w/h), with
an inner corner radius of less than 0.5 mm (
1
/
32
in).
Note
Be sure to use the supplied screws
Be sure to use the supplied screws
.
Mounting the unit in a Japanese car
You may not be able to install this unit in some
makes of Japanese cars. In such a case, consult your
Sony dealer.
makes of Japanese cars. In such a case, consult your
Sony dealer.
When mounting this unit to the preinstalled
brackets of your car, use the supplied screws
brackets of your car, use the supplied screws
in
the appropriate screw holes, based on your car: T
for TOYOTA, M for MITSUBISHI and N for NISSAN.
for TOYOTA, M for MITSUBISHI and N for NISSAN.
Note
To prevent malfunction, install only with the supplied
screws
To prevent malfunction, install only with the supplied
screws
.
For details, see “Resetting the unit” (page 7).
When replacing the fuse, be sure
to use one matching the
amperage rating stated on the
original fuse. If the fuse blows,
check the power connection and
replace the fuse. If the fuse blows
again after replacement, there
may be an internal malfunction. In such a case,
consult your nearest Sony dealer.
to use one matching the
amperage rating stated on the
original fuse. If the fuse blows,
check the power connection and
replace the fuse. If the fuse blows
again after replacement, there
may be an internal malfunction. In such a case,
consult your nearest Sony dealer.
Mounting the unit in the dashboard
Screw
Box
Larger than
97 mm (3
97 mm (3
7
/
8
in)
Larger than
172 mm (6
172 mm (6
7
/
8
in)
Installation kit (not supplied)
to dashboard/center console
Resetting the unit
Fuse replacement
to dashboard/center console
Existing parts supplied
with your car
with your car
Bracket
Bracket
Fuse (10 A)