Audiovox Voxx MTG10UHD Owner's Manual

22

This section 

covers only special installation considerations for the optional thick trim ring 

installation.  consideration for when an installation requires use of our Optional thick trim 
ring.

Important NOTES before installing the thick trim ring:

t There should be a gap between the headliner and the outer flange of the video 

monitor.

1. 

Apply masking tape to the outside of the thick trim ring.

2. 

Mark the cut line to follow the necessary contour of the roof. The suggested 
method of marking is as follows:

a. 

First mark the narrowest point of the trim ring on the masking tape.  Be 
careful to consider not only vertical location, but fore-aft location.

b.  Using the handle of a screwdriver, make a “transfer marking tool”. See 

diagram below. Place the tool against the roof and the marker against the 
masking tape on the trim ring. Trace the cut to be made around the entire 
perimeter of the trim ring.

3. 

Cut the trim ring using a sharp utility knife or shears.  Make the cut in several 
passes over the marked line, each time cutting a little deeper. It is not necessary 
to cut completely through the plastic, the cut only need be over 50% of the wall 
thickness of the plastic.  By bending the cut back and forth several times, the 
plastic will break cleanly at the cut.

4. 

Check the fit of the trimmed console and make any minor adjustments necessary.

Tape marker to screwdriver handle.

Starting at your mark for the lowest 
point,

trace the contour of the roof around 
the perimeter of the trim ring.

Headliner

Cut line

Lowest point mark