Audiovox Voxx MTG10UHD Manuel Du Propriétaire
22
Appendix B - Installing the Optional Thick Trim Ring
This section
covers only special installation considerations for the optional thick trim ring
installation. consideration for when an installation requires use of our Optional thick trim
ring.
ring.
Important NOTES before installing the thick trim ring:
t There should be a gap between the headliner and the outer flange of the video
monitor.
1.
Apply masking tape to the outside of the thick trim ring.
2.
Mark the cut line to follow the necessary contour of the roof. The suggested
method of marking is as follows:
method of marking is as follows:
a.
First mark the narrowest point of the trim ring on the masking tape. Be
careful to consider not only vertical location, but fore-aft location.
careful to consider not only vertical location, but fore-aft location.
b. Using the handle of a screwdriver, make a “transfer marking tool”. See
diagram below. Place the tool against the roof and the marker against the
masking tape on the trim ring. Trace the cut to be made around the entire
perimeter of the trim ring.
masking tape on the trim ring. Trace the cut to be made around the entire
perimeter of the trim ring.
3.
Cut the trim ring using a sharp utility knife or shears. Make the cut in several
passes over the marked line, each time cutting a little deeper. It is not necessary
to cut completely through the plastic, the cut only need be over 50% of the wall
thickness of the plastic. By bending the cut back and forth several times, the
plastic will break cleanly at the cut.
passes over the marked line, each time cutting a little deeper. It is not necessary
to cut completely through the plastic, the cut only need be over 50% of the wall
thickness of the plastic. By bending the cut back and forth several times, the
plastic will break cleanly at the cut.
4.
Check the fit of the trimmed console and make any minor adjustments necessary.
Tape marker to screwdriver handle.
Starting at your mark for the lowest
point,
point,
trace the contour of the roof around
the perimeter of the trim ring.
the perimeter of the trim ring.
THICK TRIM RING
PART NUMBERS
Shale - 1187270PL
Pewter- 1187271PL
Black- 1187272PL
Headliner
Cut line
Lowest point mark