Kicker Klock Werks® FVICXC10 FIT KIT Owner's Manual

KLOCK WERKS | VICTORY CROSS COUNTRY KICKER INSTALLATION

GETTING STARTED |

*Please reference model appropriate service manual for procedures and torque speciﬁcations.

1. Protect painted surfaces with a soft cloth.

2. Remove the seat.

3. Remove inner chin fairing and disconnect battery.

4. Disconnect

battery.

AMP INSTALLATION

5. Follow the proper procedure to remove the outer fairing

6. Install ampliﬁer to bracket using supplied hardware with harness plug facing up (Pic 1)

7. Install amp assembly to left side inner fairing support using the two existing threaded holes and

supplied 6mmx10 bolts (Pic 1)

- If the headlamp ballast is installed, place the Kicker amp bracket underneath the ballast bracket

and reuse the stock hardware.

HARNESS INSTALLATION

8. Plug harness into amp

9. Route right side speaker wires behind the inner fairing support toward the right side speaker pod (Pic 2)

10. Route the left side speaker wires toward the left side speaker pod

11. Locate the 6-place molex connector with the brown/pink wire. (Pic 3)

12. Remove the brown/pink wire from the connector and replace that socket with the one on the
Kicker

harness.

(pic 4a and pic 4b)

13. Connect the pin on the blue wire of the Kicker harness with the brown/pink socket removed in step 5

and activate the supplied heat shrink over the connection. (pic 5a and pic 5b)

14. Follow the proper procedure to remove the left side chin fairing, seat and fuel tank

15. Route the power leads:

1. Along the left side of the frame neck

2. Follow the existing harness down the left side frame tube toward the battery, using supplied zip ties

to secure the harness

3. Connect the positive lead to the battery side of the main breaker (Pic 6)

4. Leave the negative lead disconnected at this time

(HARNESS INSTALLATION PHOTOS CAN BE FOUND ON PAGE 3)