Kicker Klock Werks® FVICXC10 FIT KIT Owner's Manual

KLOCK WERKS | VICTORY CROSS COUNTRY KICKER INSTALLATION

(HARNESS INSTALLATION INSTRUCTION CAN BE FOUND ON PAGE 2)

SPEAKER INSTALLATION

16. Remove the four fasteners for each speaker, pull the speaker from the housing and disconnect the

stock speaker terminals

17. Route the left side speaker wires into the left speaker pod

18. Connect the male ends from the ampliﬁer harness into the stock speaker terminals

19. Connect the female ends from the ampliﬁer harness to the new speaker from the kit

20. Install the speaker back into the housing using the hardware removed in step 16 and the supplied washers

behind each bolt (Pic 7 above)

21. Repeat for right side speaker

22. Be sure to check that none of the wires will be in a bind when the steering head is turned fully to the

right or the left

23. Connect negative power lead to the battery and check system operation

Note: At this time, it is highly recommended to follow the guidelines in your Kicker PX 100.2 owner’s manual

to set up the ampliﬁer. Klock Werks recommends that the dip switches be set up as follows:

AUTO TURN-ON - 12V
INPUT LEVEL - HI
HI-PASS – OFF
INPUT GAIN CONTROL – Follow the instructions in your Kicker PX 100.2 owner’s manual Pg. 4

24. Disconnect negative battery terminal and carefully reassemble motorcycle

25. Reconnect negative battery terminal, reassemble chin fairing and enjoy your Kicker audio system!