Crown XLS 2002 Owner's Manual
XLS DriveCore 2 Series Power Amplifiers
Operation Manual
page 6
Indicators:
Signal Presence Indicator: Two green LED’s, one for each channel, illuminate when the channel input
signal exceeds -40dBu.
signal exceeds -40dBu.
-20 Indicator: Green LED flashes when output signal level exceeds -20dB below clip.
-10 Indicator: Green LED flashes when output signal level exceeds -10dB below clip.
Clip Indicator: Two red LED’s, one for each channel, illuminate when the channel’s output is being overdriven.
Thermal Indicator: Two red LED’s, one for each channel, illuminate when thermal compression begins.
Cooling Vents:
Front to rear forced air flow.
Gain (Level) Controls:
Two black rotary level controls,
one for each channel.
one for each channel.
Menu/Prev/Next:
Three buttons located near the
LCD screen that are used to
configure and access the
integrated processing.
LCD screen that are used to
configure and access the
integrated processing.
Power Button
Turns amplifier power on and off.
LCD Screen:
Back-lit LCD screen allows for
crossover configuration,
amplifier mode configuration,
and system configuration.
crossover configuration,
amplifier mode configuration,
and system configuration.
Blue LEDs:
LEDs will illuminate when
power is turned on or blink
while in sleep mode.
power is turned on or blink
while in sleep mode.
Binding Post Output Jacks:
One pair per channel, accepts banana plugs or
bare wire. Note: Binding post outputs on European
models come with safety plugs installed to prevent
European power plugs from being inserted. The
side entry positions for these connectors should
be used with European models.
bare wire. Note: Binding post outputs on European
models come with safety plugs installed to prevent
European power plugs from being inserted. The
side entry positions for these connectors should
be used with European models.
Fans:
Provide front to back
forced airflow for cooling.
forced airflow for cooling.
AC Power
Connector
Connector
AUX Connector
Allows sleep mode
with a contact closure
between pins 1 & 2.
with a contact closure
between pins 1 & 2.
4-Pole Speakon
®
Output Connectors:
Two - 1/4 inch input connectors accept 2-pole or
4-pole Speakon connectors. The Channel 1
connector is wired for both channels so it can be
used for BRIDGE mode wiring or stereo wiring of
two speakers to a single Speakon.
4-pole Speakon connectors. The Channel 1
connector is wired for both channels so it can be
used for BRIDGE mode wiring or stereo wiring of
two speakers to a single Speakon.
¼ Inch Inputs:
2 – ¼ Inch input connectors
are provided (one per
channel). These inputs can
also be used to loop-thru
signal to additional amplifiers.
are provided (one per
channel). These inputs can
also be used to loop-thru
signal to additional amplifiers.
Circuit Breaker:
Provides overload protection.
RCA (Phono) Inputs:
Two RCA inputs are provided
(one per channel).
(one per channel).
Balanced XLR Inputs:
Two 3-pin XLR input
connectors are provided
(one per channel).
connectors are provided
(one per channel).
Amp status signal
available at pin 3.
available at pin 3.
Front Panel Features
Back Panel Features