Crown XLS 2002 Owner's Manual

The INPUT-Y mode directs the input signal form Channel 1 to both amplifier 
output channels. This mode is often configured to use a Low Pass filter on 
Channel 1 and a High Pass filter on Channel 2 as a crossover to drive bi-
amplified systems.

Before you get started ensure that you:

1.     Connect signal source to Channel 1 only using either the XLR, ¼ Inch, or 

RCA connectors. Any source connected to Channel 2 will be ignored.

2.     Connect a speaker to each channel output using Speakon

®

, Banana Plugs,  

or bare wire.

Follow these quick steps to configure the amplifier for INPUT-Y mode:

1.     Hold the MENU/SEL button for 1 second until the LCD screen displays the 

MAIN MENU.

2.     Highlight AMP MODE and press the MENU/SEL button to enter the AMP 

MODE menu.

3.     Press the NEXT button until INPUT-Y is highlighted and press the MENU/SEL 

button to select INPUT-Y mode.

4.     Now the LCD screen displays the MAIN MENU. You may continue to the 

CROSSOVER menu to set up filter options or scroll down to EXIT to return the 
status screen which will now show the amplifier is in INPUT-Y mode.

The PureBand Crossover System provides a variable state Linkwitz-Riley 24dB/octave filter allowing you to choose a point between 30Hz and 3kHz on standard 1/12th 
octave centers.  Three filter types are available: Low Pass, High Pass and Band Pass.

For instructions on setting up the different crossover filter settings, please see the System Configuration Examples in the following section of this manual.

The Peak

X

 Limiters provide your amplifier and system with higher performance and better protection. They are specifically tuned to work with this amplifier design and 

power-supply to achieve higher SPL with less audible artifacts while protecting your loudspeaker investment.