Yamaha YSP-5600 Digital Sound Projector Owner's Manual

PREPARATIONS

➤ a Installation

En

This unit reflects sound beams off of walls and a ceiling to create the surround sound effect. The position of this unit in relation to the listening position, walls, and a ceiling is important 
to achieving the desired surround sound effects. Refer to pages 12 to 16 when installing the unit. When installing this unit on a rack behind which there is limited space, for example, 
it may be easier to connect external devices to this unit first. This will depend upon the installation location. See pages 22 to 25 for information regarding the connection of external 
devices.

a

• Be sure to install this unit on a large, stable stand where it does not fall subject to vibrations, such as from an earthquake, and where it is out of the reach of children.

• There is a built-in antenna on the top of the unit. Do not install it on a metal rack, and do not stack metal items on top of the unit.

• The unit’s speakers are not magnetically shielded. Do not install hard disk drives or similar devices near the unit.

• Do not stack the unit directly on top of other playback devices, or vice versa. Heat and vibrations may result in damage or malfunction.

1

Height channel audio is output in a diagonal 
direction upward and forward from the unit (p. 5).

2

Depending upon the rack, table-top stand, or 
floor stand used, the stands may not be 
necessary.

• Install the unit in the center of the left and right 

walls.

• This unit can be mounted on a wall (p. 17). 

• The listening position (such as sofa, etc.) should be 

located at the front of the unit.

• The distance between the listening position and the 

unit should be more than 1.8 m (6 ft).

• Set the listening position as far from the back wall as 

possible (the optimal listening position is halfway 
between the unit and the back wall, or slightly closer 
to the back wall).

• To achieve desired surround sound effects, be 

sure that obstacles such as furniture may not 
obstruct the path of sound beams (p. 13).

• Be sure that the unit installed with at least 5 cm 

of empty space above and below it.

• Leaving as much space as possible in a 

diagonal direction in front of, and above, the 
unit when installing it.

1

• Attach the supplied stands to the unit if it will 

be installed on a rack 

2

 (p. 16).