Yamaha YSP-5600 Digital Sound Projector Owner's Manual

NETWORKS

➤ Connecting to a network

En

You can choose between wired network connection and wireless network connection depending upon your network environment.

• Some security software installed on your computer, or network device settings (such as a firewall), may 

block the unit’s access to your computer or Internet radio stations. Should this occur, change security 
software and/or network device settings.

• A network connection cannot be established if the MAC address filter on your router is enabled. Check your 

router’s settings.

• To configure your router’s subnet mask manually, apply the same subnet used by this unit to all devices.

• Use of a broadband connection is recommended when using Internet services.

• If your router supports DHCP, network settings for the unit need not be configured. Network parameters 

(such as the IP address) will be assigned automatically. If your router does not support DHCP, or if you 
prefer to configure network parameters manually, you must configure network settings yourself (p. 80).

• You can verify that network parameters (such as the IP address) have been properly assigned to the unit by 

selecting “Information” (p. 78) from the setup menu.

Does the router support a wireless 

connection?

Do you use the dedicated app, 
MusicCast CONTROLLER, on 

your mobile device?

Wireless network (using the MusicCast CONTROLLER app)

Refer to the supplied “MusicCast Setup Guide”.

Use a wired network.

Is your iOS device running iOS 

7.1 or later?

Wireless network (sharing iOS device settings)

Use an iOS device (such as an iPhone) to apply network settings (p. 52).

Is your wireless router equipped 

with a WPS button?

Wireless network (using the WPS button)

Use the WPS button on your wireless router (access point) (p. 53).

Does your wireless router 

support entry of a WPS PIN 

code?

Wireless network (using the WPS PIN code)

Register the unit’s PIN code with your wireless router (access point) (p. 57).

Wireless network (searching for an access point)

Select an access point from a list of available access points (p. 53).

Wireless network (configuring a wireless connection manually)

Enter required information, such as the SSID, manually (p. 55).

Yes

Yes

No, or a wired connection is preferred.

No, not sure yet

If the connection was not successful...

Yes

If the connection was not successful...

No, not sure yet

If the connection was not successful...

If the connection was 
not successful...

Yes

No, not sure yet

Yes

No, not sure yet

If the connection was not successful...

Wireless connection fails, or no access point is displayed.