Yamaha YSP-5600 Digital Sound Projector Owner's Manual
APPENDIX
➤ Troubleshooting
En
90
APPENDIX
Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below or if the instruction below does not help, turn off the unit,
disconnect the AC power supply cable, and contact the nearest authorized Yamaha dealer or service center.
disconnect the AC power supply cable, and contact the nearest authorized Yamaha dealer or service center.
General
Troubleshooting
Problem
Cause
Remedy
See page
This unit does not operate
properly.
properly.
The internal microcomputer has been frozen by an external electric shock
(such as lightning or excessive static electricity) or by a power supply with
low voltage.
(such as lightning or excessive static electricity) or by a power supply with
low voltage.
Disconnect the AC power supply cable from the outlet and plug it again in
after 30 seconds.
after 30 seconds.
–
This unit fails to turn on when the
z key is pressed, or the unit is
turned off soon after the power
has been turned on.
z key is pressed, or the unit is
turned off soon after the power
has been turned on.
The AC power supply cable is not firmly connected to the AC wall outlet.
Connect the AC power supply cable firmly to the AC wall outlet.
The internal microcomputer has been frozen by an external electric shock
(such as lightning or excessive static electricity) or by a power supply with
low voltage.
(such as lightning or excessive static electricity) or by a power supply with
low voltage.
Disconnect the AC power supply cable from the outlet and plug it again in
after 30 seconds.
after 30 seconds.
–
“PANEL LOCK” is set to “ON”.
Set to “OFF”.
This unit is suddenly turned off.
The internal temperature becomes too high and the overheat protection
circuitry has been activated.
circuitry has been activated.
Wait for about 1 hour for this unit to cool down, turn it back on after
confirming an adequate amount of ventilation space and not to cover this
unit with a cloth.
confirming an adequate amount of ventilation space and not to cover this
unit with a cloth.
When the Auto Power Standby function is enabled, this unit turns off
automatically in any of the following situations:
– Audio is coming from the selected input source, but no operations have
automatically in any of the following situations:
– Audio is coming from the selected input source, but no operations have
been performed for 8 hours or more.
– HDMI1–4, Bluetooth or NET is selected as the input source, but no audio
has been input to the unit or no operations have been performed with the
unit for more than 20 minutes.
unit for more than 20 minutes.
Turn on the power of the unit and play back the source again. If the Auto
Power Standby function is not used, set “AUTO POWER STANDBY” to
“OFF”.
Power Standby function is not used, set “AUTO POWER STANDBY” to
“OFF”.
The network standby function has been activated, terminating the Bluetooth
connection.
connection.
Resume the Bluetooth connection using the Bluetooth device, or turn on
this unit and disable the network standby function.
this unit and disable the network standby function.