Sony STR-DH770 Owner's Manual
30
GB
D:\NORM'S JOB\SONY HA\SO160004\STR-DH770 (PMRF 04)\4584079132_GB\030CON.fm
masterpage: Left
STR-DH770
4-584-079-13(2)
2
Connect the supplied
calibration microphone to
CALIBRATION MIC jack. Set up
the calibration microphone at
your listening position.
calibration microphone to
CALIBRATION MIC jack. Set up
the calibration microphone at
your listening position.
The speakers emit very loud sound during
the calibration and the volume cannot be
adjusted. Be considerate of your neighbors
and any children who are present.
the calibration and the volume cannot be
adjusted. Be considerate of your neighbors
and any children who are present.
If the muting function has been activated
before you perform Auto Calibration, the
muting function will shut off automatically.
before you perform Auto Calibration, the
muting function will shut off automatically.
It may not be possible to take the correct
measurements or to perform Auto Calibration
at all if special speakers such as dipole
speakers are used.
measurements or to perform Auto Calibration
at all if special speakers such as dipole
speakers are used.
3
Select [Proceed].
4
Select [Proceed] again.
The measurement process will take
approximately 30 seconds with a test
tone.
When the measurement ends, a beep
sounds and the screen switches.
approximately 30 seconds with a test
tone.
When the measurement ends, a beep
sounds and the screen switches.
If the measurement fails, follow the message,
then select [Retry]. For details on the error
code and warning message, see “List of
messages after Auto Calibration
measurements” (page 37).
then select [Retry]. For details on the error
code and warning message, see “List of
messages after Auto Calibration
measurements” (page 37).
5
Confirm the measurement
results.
results.
[Retry]: Performs the Auto Calibration
again.
again.
[Save&Exit]: Save the measurement
results and exits the setting process.
results and exits the setting process.
[Exit]: Exits the setting process without
saving the measurement results.
saving the measurement results.
The measurement results may vary depending
on the position of the subwoofer. However,
continuing to use the receiver with that value
does not cause problems.
on the position of the subwoofer. However,
continuing to use the receiver with that value
does not cause problems.
Note
Calibration
microphone
(supplied)
microphone
(supplied)
Note
Tip