Canon EOS 77D Telephoto Lens Kit Owner's Manual

207

3

 Auto Exposure BracketingN



Follow steps 1 and 2 to turn off the AEB range display (set to 0).



The AEB setting will also be canceled automatically if the power 
switch is set to <2>, flash recharging is complete, etc.



Using AEB with continuous shooting
If you set the drive mode to <o> or <i> (p.147) and press the 
shutter button completely, the three bracketed shots will be taken 
consecutively in the sequence of standard exposure, decreased 
exposure, and increased exposure, and then the camera will 
automatically stop shooting.



Using AEB with single shooting (u)
Press the shutter button three times to take the three bracketed 
shots. The three bracketed shots will be taken in the following 
sequence: standard exposure, decreased exposure, and increased 
exposure.



Using AEB with the self-timer or a remote controller (sold 
separately)
With the self-timer or a remote control shooting (<Q> or <l>), 
you can take three consecutive shots after a 10-sec. or 2-sec. delay. 
With <q> (p.149) set, the number of consecutive shots will be 
three times the number set.



During AEB, <A> and AEB range in the viewfinder will blink.



AEB cannot be used with flash, when [Multi Shot Noise Reduction] is 
set, for shooting with a Creative filter, or with bulb exposures.



If [z2: Auto Lighting Optimizer] (p.175) is set to any setting other than 
[Disable], the effect of AEB may be reduced.