Yamaha R-N803 Owner's Manual

Configure the system settings of the unit using the front 
panel controls.

Press A (power) to turn off the unit.

While holding down RETURN, press A (power).

Press A (power) to set the unit to turn off and 
turn it on again.
The new settings take effect.

Check the version of firmware currently installed on the 
unit.

• You can also check the firmware version in “Update (Network 

Update)” (p. 50) in the “Setup” menu.

• It may take a while until the firmware version is displayed.

Change the unit’s speaker impedance settings depending 
on the impedance of the speakers connected.

Change the unit’s remote control ID so that it matches the 
remote control’s ID.
Select “ID1” normally. Select “AUTO” only when you 
use the remote control supplied with some Yamaha player.

Settings
ID1 (Default), AUTO

Checks the version of firmware 
currently installed on the unit.

Changes the speaker impedance 
setting.

Selects the unit’s remote control ID.

(Asia and General models only)
Sets tuner frequency step.

Restores the default settings.

Updates the firmware.

A (power)

 MIN

Select this option when you connect speakers with 
an impedance of 4 ohms to less than 8 ohms to the 
unit.

 MIN

Select this option when you connect speakers with 
an impedance of 8 ohms or more to the unit.

VERSION••xx.xx

SP IMP.••8¬MIN

REMOTE ID••ID1