Thunder Tiger Corp. COMMANDER User Manual
Radio installation
Before installing your radio into your model, connect the receiver, servos, and switch
harness/battery pack as shown. In addition to checking for proper operation, this "bench test" helps
you become familiar with the operation of your radio. Begin by turning on the transmitter, and then
turn on the receiver switch. Make sure that all servos and trims levers are operating, and take a few
moments to "play" with your system. After completion of your bench testing, turn off the receiver,
followed by the transmitter.
harness/battery pack as shown. In addition to checking for proper operation, this "bench test" helps
you become familiar with the operation of your radio. Begin by turning on the transmitter, and then
turn on the receiver switch. Make sure that all servos and trims levers are operating, and take a few
moments to "play" with your system. After completion of your bench testing, turn off the receiver,
followed by the transmitter.
CAUTION
To prevent loss of radio range do not kink or
cut the gray wire, do not bend or cut the
metal tip, and do not bend or cut the white
wire at the end of the metal tip.
HELPFUL HINT
1. The two antennas must be
kept as straight as possible.
Otherwise it will reduce the
effective range.
2. The two antennas should be
placed at 90 degrees to each
other.
CH5
Switch
Harness
Harness
Receiver
Receiver
Battery
Battery
CH9
PPM SUM
CH8
CH7
CH6
3