Thunder Tiger Corp. COMMANDER User Manual

The Commander transmitter was specifically-designed to operate air models. Basic functions for 
this transmitter are listed below.  

Binding process may take 2~4 seconds to execute. If binding fails, the LED light on the receiver will 

turn red. Please turn off power and repeat the above steps from a) ~ e). 

a) Turn On/Off

After installing the transmitter batteries, turn on the 
transmitter power by sliding up the switch located on 
the front middle position of the transmitter. The LED 
light turns “GREEN”. To turn off the power, slide down 
the switch, the LED indicator light will turn off.

b) Low Battery Power Warning

If the transmitter battery power is too low, a “Bi--Bi--” 
warning tone will be emitted and the LED indicator will 
flash “GREEN”. It’s very dangerous to fly the model 
with  low  battery  transmitter.  Please change the 
batteries immediately.

A binding feature is included in the Commander 2.4 GHz 
spread  spectrum  system  to  ensure  the  transmitter  and 
receiver  bind    properly  and  prevent  interference  from 
other  controllers.  To  bind  Tx/Rx,  please  proceed  as  per 
the following: 

a) Press and hold “Binding SW” button located on the 

transmitter.

b) Simultaneously, turn on the power.
c) Release the “Binding SW” button. The binding LED 

will blink Green / Red, indicating the transmitter is 
binding.

d) Press and hold the BINDING push button on the 

Receiver, plug the  battery power connector on the 
receiver to turn power on. Then  release the 
BINDING button.

LED

Binding Switch

Receiver
6CH

e) Successful binding is confirmed by the binding LED 

changing from Green / Red to a Green flash on the 
transmitter. The LED will turn green on the receiver. Upon confirmation, turn off power of 
the receiver and transmitter and launch normal start-up procedures. 

4