Thunder Tiger Corp. COUGARGP3 User Manual
Gas Power Model Installation
BATTERY HOLDER
4.8V RX
BATTERY PACK
BATTERY PACK
CH1
CH2
BATT
STEERING SERVO
THROTTLE SERVO
RECEIVER
Electric Power Model Installation
MOTOR
7.2V POWER BATTERY PACK
CH2
CH1
ESC
RECEIVER
Radio installation
1) Connect the receiver, servos, and switch hardness/battery pack as shown.
2) If you are not familiar with all the control systems. Do the “bench test” before to install all the devices on the model.
3) Always follow the “transmitter on first, off last” procedure.
4) Always install the receiver as far as possible from the motor, ESC, power battery, motor wires.. or other noise sources.
2) If you are not familiar with all the control systems. Do the “bench test” before to install all the devices on the model.
3) Always follow the “transmitter on first, off last” procedure.
4) Always install the receiver as far as possible from the motor, ESC, power battery, motor wires.. or other noise sources.
Especially, do not route the motor wires next to the receiver, crystal or receiver antenna.
To prevent loss of radio range do not kink or cut
the gray wire, do not bend or cut the metal tip, and
do not bend or cut the white wire at the end of the
metal tip.
the gray wire, do not bend or cut the metal tip, and
do not bend or cut the white wire at the end of the
metal tip.
!
6