Thunder Tiger Corp. TT-FHM2P4G-A14 User Manual

FAIL SAFE (F/S) FUNCTION SETTING

ACE RC COUGAR 2.4GHz R/C system features a built-in Failsafe function to

automatically set a servo command if the receiver loses the signal from transmitter due

to interference. For safety, we strongly recommend to active the FAILSAFE function on

your Cougar R/C system.

After binding the transmitter and receiver, you can continually set up the F/S function. Turn on the transmitter

power and then receiver power.

Press and hold the “Binding SW” button on the receiver for 2~4 seconds. The LED will start flashing GREEN

on the receiver.

Move and hold the throttle trigger to the position you want the control to be in if a failsafe condition should

occur. First, keep steering wheel at neutral position (steering servo at neutral position). To set up F/S function

with the throttle servo position at "Brake", first push the trigger to the brake position and hold. To set up F/S

function with servo position at "Neutral", keep the trigger at neutral position.

After the Step C, release the “Binding SW” button on the receiver first and then the throttle trigger. The LED

turns to solid “RED” and then back to solid “GREEN” indicating the F/S function has now been activated.

Test by turning off your transmitter and watching the servo failsafe position activate.

F/S at "Neutral": To check the fail safe is working properly, by moving the throttle trigger to the full forward

(full brake), hold this position and then turn off the transmitter. The F/S function should move the throttle servo

to “Neutral” position and the steering servo to “Neutral” position.

F/S at "Brake": To check the fail safe is working properly, by keeping the throttle trigger at neutral and then

turn off the transmitter. The F/S function should move the throttle servo to “Brake” position and the steering

servo to “Neutral” position.

If the F/S function fails or need to change the F/S hold position, repeat the steps a) ~e). After the F/S is

completed, you can start normal operation.

Setting up the Failsafe (F/S) Function:

CAUTION: Do not release the “Binding SW” button on the receiver until STEP C is completed.

CAUTION:

FAILSAFE function will be reset after binding your transmitter & receiver.

NOTE:

Always set the throttle trigger to neutral or full brake position and steering servo to neutral position in
case of any unexpected control error!

Factory pre-settings for RC car F/S function are :
Electric Car- Steering servo at neutral, throttle at neutral.
Nitro Car- Steering servo at neutral, throttle at idle.

2.4GHz Digital Radio System