Thunder Tiger Corp. TT-FHM2P4G-A14 User Manual

Menu

Value Display
Status Display

Trim position ruler

There are 4 distinct areas on the screen: “Menu”, “Value 

Display”, “Status Display”, and “Trim position ruler”. 

Using the left and right “Edit Buttons”, the cursor will 

jump to the function you would like to edit. When you 

enter the menu function, you can press the up and 

down “Edit Buttons” to edit the value. Upon completing 

settings, simply press the right and left buttons to move 

the cursor to other functions, the previous value is now 

saved.

Slide up the “Power Switch” to turn on the radio. You will hear a short “Beep” tone. The “model number”(         ) 
will be displayed on the “Menu” area, the battery voltage value”(             ) will be displayed on “Value Display” 
area, and  “battery voltage status diagram”(                 ) / transmitter system ( “         ” ) and audio on/off setting 
( “      ” ) RF Transmitting on/off (       )  will be shown on “Status Display” area. 

The current neutral position of the steering and throttle servos are displayed on “Trim position rulers”. 

If all the radio system and RF module are correct, and the switch is set on the “ON” position, then the RF 

Transmitting sign (      ) will be shown on the “Status Display” to make you use the current model No setting to 

play your model. Or use the “Edit Buttons” to start the programming procedure. The following are the set-up 

procedure and detail description for each function.

1) Battery status is easily read on the voltage value or battery status diagram. Charge or change the battery 

when the voltage is lower than 8.8V. 

2) For the radio RF system, the Cougar P3i feaatures PPM system, so the 

PPM is shown on the display.

3) If you plan to study all the function setting 

procedure, or to adjust many functions data, we 

strongly suggest to cancel the RF transmitting 

function before executing the setting procedure. 

You can remove the RF module or put the power 

switch on the “Display” position. Note that the RF 

Transmitting sign (     ) will not be shown on the 

display.

The audio default setting is “On” eventhough no icon is displayed on the screen. Under the “Audio on” mode, a 

"Beep" is emitted whenever the edit button or digital trim lever is operated. The radio can be switched to 

“silent” mode easily. When switched to “Silent” mode, the “      ” icon is displayed on the right lower "Status 

Display" .