Atech OEM Inc. BU4086 User Manual

Quick Installation Guide

PC System Requirements

●

one available USB port

●

Windows XP

Step 1：Software Setup

Note: please do not insert the USB adapter
into the USB port prior to software installation.

Step 1. Put the CD-Rom into the computer`s CD drive

and click the software installation button for

"Windows XP" system.

Step 2. The software lnstallShield wizard window appears,

click "Next" to start the installation.

Step 3. Choose “ l accept the terms in the license

agreement” then click "Next" to continue.

Step 8. Click "Finish" to confirm the completion of the

software installation.

Step 5. Confirm the software is ready to be installed and

click "lnstall".

Step 6. During the installation process,you may be

prompted to insert your USB adapter as below

window, please insert your USB adapter and click

"OK", or click "Cancel" to continue installation

without the USB adapter.

Step 7. The lnstallShield Wizard will continue to install

the Bluetooth software.

Step 4. Specify the location where the software files will

be installed on hard drive.then click "Next" to

continue.

BTW 5

Step 2：Hardware Setup

Insert the USB adapter directly to a available
USB connector on your computer,
the system should register a new usb device
found. Please follow below instructions to
complete the Bluetooth installation on your
PC :

Step 1. Initialize Bluetooth setup wizard and choose the

location of Bluetooth hardware installation, click

"Next" to continue next steps until the Bluetooth

icon built up at tool-bar or front-table of your

computer system.

Step 2. Setup your computer device and type for

recognition,click "Next" to continue Bluetooth

setup.

Step 3. Click "Next" to configure the Bluetooth service.

Step 4. Click "Next" to configure the Bluetooth service.Please

enable the remote Bluetooth device which you want

to make connection, then the device would be

searched.

Step 5. The PIN code shown automatically,please check the

same with paired devices,then click "Next" to

continue.

Step 6. Click “Flinish” to confirm the USB adapter with paired

device connect done.

*To Start / Stop the BluetoothWhen the
mini adapter is plugged, you can
Right-click the Bluetooth icon in the
tool-bar:

select "Start the Bluetooth Device" to
turn on the adaptor

(icon color changes towhite)

select "Stop the Bluetooth Device" to
turn on the adaptor

(icon color changes to red)

This device complies with Part
15 of the FCC Rules.Operation
is subject to the following two
conditions :
(1) device may not cause
harmful interference, and
(2) this device must accept any
interference received,
including interference that may
cause undesired operation.

Caution :

changes or modifications not expressly

approved by theparty responsible for compliance

could void the user's authority tooperate the

equipment.

0681