Atech OEM Inc. BU4086 Manual Do Utilizador
Quick Installation Guide
PC System Requirements
●
one available USB port
●
Windows XP
Step 1:Software Setup
Note: please do not insert the USB adapter
into the USB port prior to software installation.
into the USB port prior to software installation.
Step 1. Put the CD-Rom into the computer`s CD drive
and click the software installation button for
"Windows XP" system.
Step 2. The software lnstallShield wizard window appears,
click "Next" to start the installation.
Step 3. Choose “ l accept the terms in the license
agreement” then click "Next" to continue.
Step 8. Click "Finish" to confirm the completion of the
software installation.
Step 5. Confirm the software is ready to be installed and
click "lnstall".
Step 6. During the installation process,you may be
prompted to insert your USB adapter as below
window, please insert your USB adapter and click
"OK", or click "Cancel" to continue installation
without the USB adapter.
Step 7. The lnstallShield Wizard will continue to install
the Bluetooth software.
Step 4. Specify the location where the software files will
be installed on hard drive.then click "Next" to
continue.
BTW 5
Step 2:Hardware Setup
Insert the USB adapter directly to a available
USB connector on your computer,
the system should register a new usb device
found. Please follow below instructions to
complete the Bluetooth installation on your
PC :
USB connector on your computer,
the system should register a new usb device
found. Please follow below instructions to
complete the Bluetooth installation on your
PC :
Step 1. Initialize Bluetooth setup wizard and choose the
location of Bluetooth hardware installation, click
"Next" to continue next steps until the Bluetooth
icon built up at tool-bar or front-table of your
computer system.
Step 2. Setup your computer device and type for
recognition,click "Next" to continue Bluetooth
setup.
Step 3. Click "Next" to configure the Bluetooth service.
Step 4. Click "Next" to configure the Bluetooth service.Please
enable the remote Bluetooth device which you want
to make connection, then the device would be
searched.
Step 5. The PIN code shown automatically,please check the
same with paired devices,then click "Next" to
continue.
Step 6. Click “Flinish” to confirm the USB adapter with paired
device connect done.
*To Start / Stop the BluetoothWhen the
mini adapter is plugged, you can
Right-click the Bluetooth icon in the
tool-bar:
mini adapter is plugged, you can
Right-click the Bluetooth icon in the
tool-bar:
select "Start the Bluetooth Device" to
turn on the adaptor
turn on the adaptor
(icon color changes towhite)
select "Stop the Bluetooth Device" to
turn on the adaptor
turn on the adaptor
(icon color changes to red)
This device complies with Part
15 of the FCC Rules.Operation
is subject to the following two
conditions :
(1) device may not cause
harmful interference, and
(2) this device must accept any
interference received,
including interference that may
cause undesired operation.
15 of the FCC Rules.Operation
is subject to the following two
conditions :
(1) device may not cause
harmful interference, and
(2) this device must accept any
interference received,
including interference that may
cause undesired operation.
Caution :
changes or modifications not expressly
approved by theparty responsible for compliance
could void the user's authority tooperate the
equipment.
0681