Shenzhen Neo-Point Communication LANSO User Manual
PAGE 3 / 6
1. Charging LANSO A6+
Your headset is delivered uncharged. So before the first use, you must fully recharge
it for about 8 hours with the supplied charger, until the red indicator light turns off.
The use of any other charger will automatically suspend the warranty. During
subsequent charges, the charging should take approximately 2 hour.
Please connect the charger to the headset and to the mains. During the charge, the
indicator light is red, The red indicator light will turns off when the charge is complete.
When you hear a light beep in your headset at regular intervals, and the indicator
light flashes in red, your headset needs to be recharged.
To maximize battery lifetime, it is recommended to recharge your headset to full
capacity only when the battery is low, since a battery has a lifetime of about 500
charging cycles.
it for about 8 hours with the supplied charger, until the red indicator light turns off.
The use of any other charger will automatically suspend the warranty. During
subsequent charges, the charging should take approximately 2 hour.
Please connect the charger to the headset and to the mains. During the charge, the
indicator light is red, The red indicator light will turns off when the charge is complete.
When you hear a light beep in your headset at regular intervals, and the indicator
light flashes in red, your headset needs to be recharged.
To maximize battery lifetime, it is recommended to recharge your headset to full
capacity only when the battery is low, since a battery has a lifetime of about 500
charging cycles.
If you leave your headset battery empty for an extended period of time, it could
excessively discharge the battery. In this case, you may have to charge your headset
for 10 hours .
Do not let the battery charger remain plugged in the headset for more than 24h.
excessively discharge the battery. In this case, you may have to charge your headset
for 10 hours .
Do not let the battery charger remain plugged in the headset for more than 24h.
2. Pairing LANSO A6+
Before using the LANSO A6+ headset, you must pair it with your Bluetooth ® mobile
phone. Pairing is the process of linking 2 Bluetooth ® devices, so that they can
communicate.
The pairing only needs to be done once. Afterwards, every time you switch on your
headset, it will automatically connect to your mobile phone. If you pair your
Bluetooth ®mobile phone with another Bluetooth ® device, you will have to pair the
LANSO A6+ with your phone again before use.
The profile (Headset or Hands-Free) is automatically selected by the Mobile phone
during the Pairing stage.
IMPORTANT : Before pairing, all bluetooth devices must be switched off.
To initiate the pairing, put both the headset and the mobile phone within 0.3 meter (1
foot) from each other.
foot) from each other.
1. Switch on your phone and select the Bluetooth ® discover mode on the
Mobile phone (See the Bluetooth ® mobile phone user guide).
2. Press and hold (do not release it) the TALK button (see TALK button on page
2) for about 7 seconds until the indicator light flashes red and green
alternatively. Then release the TALK Button. A beep can be heard in the
speaker.
alternatively. Then release the TALK Button. A beep can be heard in the
speaker.
3.Once the mobile phone detects the headset, a message is displayed with the
following information : “LANSO ”.