MagTek 21165046 User Manual
Section 2. Installation
15
Accessing SAM Module
If the contactless module is installed, it must be removed temporarily in order to access the SAM
module. The two screws holding the contactless module onto the IntelliStripe 65 circuit board
will have to be removed in order to reach the SAM module which is located under the
contactless module (see Figure 2-9).
If the contactless module is installed, it must be removed temporarily in order to access the SAM
module. The two screws holding the contactless module onto the IntelliStripe 65 circuit board
will have to be removed in order to reach the SAM module which is located under the
contactless module (see Figure 2-9).
Figure 2-9. Removing Contactless Module to Access SAM Socket
RS-232 Cable
Figure 2-10 shows the cable (P/N 16051408) that connects the IntelliStripe 65 (7-Pin Connector)
to the host (9-pin Connector). The length of the cable is 6’ (1.8m).
Figure 2-10 shows the cable (P/N 16051408) that connects the IntelliStripe 65 (7-Pin Connector)
to the host (9-pin Connector). The length of the cable is 6’ (1.8m).