PAX Technology Limited S80 User Manual

1

Figure 1

Top View

Figure 2

Bottom View

Figure 3: SAM/SIM Socket     

Figure 4

Ports at Bottom

Figure 5: S80 Wall Mounting Device

          Note: The above figure shows S80 equipped Wall Mounting Device 
                    which is optional.

2

1) Place S80 on table

2) Connect the attached cable

Remove port cover on bottom of S80

Connect each plug of the attached cables into the 

corresponding sockets on the rear panel of the terminal. 

Put the port cover back.

SAM

PINPAD

RS232A

Power

LINE

LAN /RS232B

SIM

3) Insert the telephone cord supplied with the terminal into 

standard RJ-11 type outlet. Connect the other end of the 

telephone cord into a standard RJ-11 type modular 

telephone line outlet.

  The figure below shows  cable installation.

4) Connect serial facility to RS232 socket.

5) Connect AC plug of power adaptor into AC socket.

6) Place paper roll into S80

     Press the paper cover release key  to open paper cover.

     Insert paper roll along the arrow.

     Lead the paper out and place the paper on paper cut and   

     push the paper  cover downward until  a sound of  

ka

 can 

3

be heard.

7) Turn on S80, LCD backlight is on. On screen initialization 

and application interface show on one after another.

8) To perform a simulation of transaction successfully thus 

S80 installation is OK.

1) Power on/off

Power on: Press the red button for about 2 seconds until 

LED backlight on, the POS is on.

Power off: Press the red button for about 2 seconds until the 

content of display vanishes, the POS is off.

2) Magnetic swipe

When pulling a magnetic card along the slot, make the 

magnetic stripe face the machine. Bi-directional pulling the 

magnetic card is acceptable. It is recommended from up to 

down, and with a steady speed.

3) IC card operational description

When insert a card, make the contact of the card upward. 

Gently insert and withdraw the card In order to protect the 

contact on card and IC card connector.

4) Tear paper operation

Hold the end of paper along with the paper cut as an angle 

of 45 degree and swiftly and evenly tear the paper off.

POS

Wall

POS Wall Mounting Device Wall

Wall Mounting Device

Paper cover

LCD display

On/off Key

Paper cover 
release key

ATM-style key

Keypad

IC Card slot

Privacy shield(Opt.)

Paper cutter

Room 2416, 24/F., Sun Hung Kai Centre, 30 
Harbour Road, Wanchai, Hong Kong
Tel: +852-2588 8808    Fax: +852-2802 3300
E-mail: daniel@pax.com.hk 
Website: www.pax.com.hk

®

®

®

Magnetic strip
card slot

Hang hole(Opt.)

Port cover

Nameplate 

USB port 

Bar code lable

SAM/SIM socket cover

Power 

Contactless Card Reader
Interface

Screw