PAX Technology Limited S80 Manuale Utente
Product Description
1
Product Description
Figure 1
Top View
Figure 2
Bottom View
Figure 3: SAM/SIM Socket
Figure 4
Ports at Bottom
Figure 5: S80 Wall Mounting Device
Note: The above figure shows S80 equipped Wall Mounting Device
which is optional.
which is optional.
Installation
2
Installation
1) Place S80 on table
2) Connect the attached cable
Remove port cover on bottom of S80
Connect each plug of the attached cables into the
corresponding sockets on the rear panel of the terminal.
Put the port cover back.
SAM
PINPAD
RS232A
Power
LINE
LAN /RS232B
SIM
3) Insert the telephone cord supplied with the terminal into
standard RJ-11 type outlet. Connect the other end of the
telephone cord into a standard RJ-11 type modular
telephone line outlet.
The figure below shows cable installation.
4) Connect serial facility to RS232 socket.
5) Connect AC plug of power adaptor into AC socket.
6) Place paper roll into S80
Press the paper cover release key to open paper cover.
Insert paper roll along the arrow.
Lead the paper out and place the paper on paper cut and
push the paper cover downward until a sound of
ka
can
Instruction
3
Instruction
be heard.
7) Turn on S80, LCD backlight is on. On screen initialization
and application interface show on one after another.
8) To perform a simulation of transaction successfully thus
S80 installation is OK.
1) Power on/off
Power on: Press the red button for about 2 seconds until
LED backlight on, the POS is on.
Power off: Press the red button for about 2 seconds until the
content of display vanishes, the POS is off.
2) Magnetic swipe
When pulling a magnetic card along the slot, make the
magnetic stripe face the machine. Bi-directional pulling the
magnetic card is acceptable. It is recommended from up to
down, and with a steady speed.
3) IC card operational description
When insert a card, make the contact of the card upward.
Gently insert and withdraw the card In order to protect the
contact on card and IC card connector.
4) Tear paper operation
Hold the end of paper along with the paper cut as an angle
of 45 degree and swiftly and evenly tear the paper off.
POS
Wall
POS Wall Mounting Device Wall
Wall Mounting Device
Paper cover
LCD display
On/off Key
Paper cover
release key
release key
ATM-style key
Keypad
IC Card slot
Privacy shield(Opt.)
Paper cutter
PAX TECHNOLOGY LIMITED
reserves
the right to change product technology
specifications without notifying.
specifications without notifying.
Room 2416, 24/F., Sun Hung Kai Centre, 30
Harbour Road, Wanchai, Hong Kong
Tel: +852-2588 8808 Fax: +852-2802 3300
E-mail: daniel@pax.com.hk
Website: www.pax.com.hk
Harbour Road, Wanchai, Hong Kong
Tel: +852-2588 8808 Fax: +852-2802 3300
E-mail: daniel@pax.com.hk
Website: www.pax.com.hk
PAX TECHNOLOGY LIMITED
®
®
®
Magnetic strip
card slot
card slot
Hang hole(Opt.)
Port cover
Nameplate
USB port
Bar code lable
SAM/SIM socket cover
Power
Contactless Card Reader
Interface
Interface
Screw