Accton Wireless Broadband Corp. FIU176205000W User Manual
Introduction
1-4
1
*
Slow blinking is an on-off cycle of once every 2 seconds.
**Fast blinking is an on-off cycle of once of every 0.5 seconds.
***Untra Fast flashing: on-off cycle of once of every 0.2 seconds
Ethernet RJ-45 Ports
The wireless AP/Router has the following RJ-45 ports:
• The four RJ-45 LAN ports are for connections to PCs or to a 10/100 Mbps network
• The four RJ-45 LAN ports are for connections to PCs or to a 10/100 Mbps network
switch.
• The RJ-45 WAN port is for connection to a DSL or cable modem, or to a LAN or
other device that provides your Internet access.
All RJ-45 ports auto-negotiate the operating speed to 10/100 Mbps, the mode to
half/full duplex, and the pin signals to MDI/MDI-X. Automatic MDI/MDI-X support
enables you to use straight-through cables for all network connections to PCs,
switches, or hubs.
half/full duplex, and the pin signals to MDI/MDI-X. Automatic MDI/MDI-X support
enables you to use straight-through cables for all network connections to PCs,
switches, or hubs.
3G Modem USB Port
The 3G Modem USB Port supports connection to a wireless cellular 3G or 3.5G
modem for broadband internet access.
modem for broadband internet access.
Power Socket
The wireless AP/Router does not have a power switch. It is powered on when
connected to the AC power adapter, and the power adapter is connected to a power
source. The power adapter automatically adjusts to any voltage between 100-240
volts at 50 or 60 Hz. No voltage range settings are required.
connected to the AC power adapter, and the power adapter is connected to a power
source. The power adapter automatically adjusts to any voltage between 100-240
volts at 50 or 60 Hz. No voltage range settings are required.
Reset Button
The Reset button can be used to restart the wireless AP/Router or restore the
factory default configuration. If you press the button for less than 5 seconds, the
wireless AP/Router will restart. If you press and hold down the button for 5 seconds
or more, any configuration changes you may have made are removed and the
wireless AP/Router is restored to its factory default configuration.
factory default configuration. If you press the button for less than 5 seconds, the
wireless AP/Router will restart. If you press and hold down the button for 5 seconds
or more, any configuration changes you may have made are removed and the
wireless AP/Router is restored to its factory default configuration.
Ultra Fast Flashing
Green**
Indicates that 3G usage is already over the ISP supplied limit.
Ultra Fast Flashing
Green and OFF
cycle every 5
seconds**
Indicates that 3G usage is already over the user defined pre-warning
limit.
Slow Flashing Green Indicates that the 3G/3.5G USB modem is in the process of connecting.
Off
Off
Indicates that there is no connection or no attached 3G/3.5G device.
LED
Status
Description