Code 3 Inc. NP130W User Manual

3

Connect the red and black wires from the NightProbe spotlight as shown in Figure 2.  Protect the circuit

with a 15 Amp fuse and use 14 awg (minimum) wire.

Connect the white wire from the unit to an ignition switched circuit protected by a  fuse (3

Amp Max.).  Use a 22 awg. (minimum) wire.  (see notes page 7)

 Route wiring using grommets and sealant when passing through compartment walls.  High

ambient temperatures (e.g. under-hood) will significantly reduce the current carrying capacity of

wires, fuses, and circuit breakers.  Use "SXL" type wire in engine compartment.  Minimize the

number of splices to reduce voltage drop.    All wiring should conform to the minimum wire size

and other recommendations of the manufacturer and be protected from moving parts and hot

surfaces.  Looms, grommets, cable ties, and similar installation hardware should be used to

anchor and protect all wiring. Particular attention should be paid to the location and method of

making electrical connections and splices to protect these points from corrosion and loss of

conductivity.  Ground terminations should only be made to substantial chassis components,

preferably directly to the vehicle battery. The user should install a fuse sized to approximately

125% of the maximum amp capacity in the supply line and each switched circuit to protect

against short circuits.

Any electronic device may create or be affected by electromagnetic interference.  After installation

of any electronic device, operate all equipment simultaneously to insure that operation is free of

interference.