RadioFrame Networks Inc DH2 User Manual
RadioFrame System
Introduction
RFN_3.1 Beta
5
Warning!
To comply with FCC RF exposure requirements, iDEN antennas must be installed
to provide at least 8 inches (20 cm) separation from all persons, with antenna gain
not exceeding zero (0) dBi.
to provide at least 8 inches (20 cm) separation from all persons, with antenna gain
not exceeding zero (0) dBi.
Warning!
Never defeat the ground conductor or operate the equipment in the absence of a
suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available.
suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available.
Warning!
The plug-socket combination must be accessible at all times because it serves as
the main disconnecting device.
the main disconnecting device.
Warning!
The RadioFrame Unit (RFU) is intended to be mounted on a wall. The RFU can
also be installed on or above a ceiling. Please read the RFU mounting instructions
carefully before beginning the installation. Failure to use the correct hardware or to
follow the correct procedures could result in a hazardous situation to people and
damage to the system.
also be installed on or above a ceiling. Please read the RFU mounting instructions
carefully before beginning the installation. Failure to use the correct hardware or to
follow the correct procedures could result in a hazardous situation to people and
damage to the system.
Warning!
Ultimate disposal of this product should be handled according to all national laws
and regulations.
and regulations.
1.4.2 Safety
with
Electricity
Warning!
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to
telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and
WAN ports contain TNV circuits. Some LAN and WAN ports both use RJ45
connectors; incorrect interconnection can cause equipment damage. Use caution
when connecting cables.
telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and
WAN ports contain TNV circuits. Some LAN and WAN ports both use RJ45
connectors; incorrect interconnection can cause equipment damage. Use caution
when connecting cables.
Warning!
Before working on equipment that is connected to power lines, remove jewelry
(including rings, necklaces, and watches). Metal objects will heat up when
connected to power and ground and can cause serious burns or weld the metal
object to the terminals.
(including rings, necklaces, and watches). Metal objects will heat up when
connected to power and ground and can cause serious burns or weld the metal
object to the terminals.
Warning!
Hazardous network voltages are present in WAN ports regardless of whether
power to the attached equipment is OFF or ON. To avoid electric shock, use
caution when working near WAN ports. When detaching cables, detach the end
away from the router first.
power to the attached equipment is OFF or ON. To avoid electric shock, use
caution when working near WAN ports. When detaching cables, detach the end
away from the router first.
Warning!
Do not touch the power supply when the power cord is connected. For systems
with a power switch, line voltages are present within the power supply even when
the power switch is off and the power cord is connected. For systems without a
power switch, line voltages are present within the power supply when the power
cord is connected.
with a power switch, line voltages are present within the power supply even when
the power switch is off and the power cord is connected. For systems without a
power switch, line voltages are present within the power supply when the power
cord is connected.