RadioFrame Networks Inc DH2 User Manual

RadioFrame System 

RFN_3.1 Beta

This section provides pre-installation information for a RadioFrame System at a 
RFN customer site. A pre-installation site review and evaluation helps prevent 
potential equipment installation problems. Consider every subject discussed in 
this section before installing the iDEN/802.11b RFS.  

The main rack is provided pre-installed with the following equipment: 

• 

Rectifier, PECO II 

• 

NCU (Network Chassis Unit), RadioFrame Networks 

• 

ACU (Airlink Chassis Unit), RadioFrame Networks 

• 

CSU (Channel Service Unit), DTS 

• 

EAS (Environmental Alarm System), Motorola 

• 

two iSC-3s (integrated Site Controllers), Motorola 

• 

two battery trays, 2 x 100 amp batteries 

All other equipment is RadioFrame Networks equipment and is shipped as 
follows:  each RFU, remote ACU, and URU is shipped in its own box. The iDEN 
RadioBlades and RAPs are shipped several to a box and individually wrapped in 
antistatic packaging. Unpack each unit only at the time of installation—leave 
items in their shipping containers until ready for use. Unpacking instructions are 
contained inside each shipping container.  

Inspect the RadioFrame Networks iDEN solution equipment immediately upon 
receipt. If obvious damage has occurred to shipping containers before 
unpacking, contact the shipping agent. Ask that a representative of the shipping 
company be present while the equipment is unpacked. Observe guidelines for 
safe handling of electrostatic sensitive devices or equipment to prevent damage 
due to electrostatic discharge. A conductive wrist strap is provided with each 
RFU and should always be worn when handling any electrical component, 
including iDEN RadioBlades.  

Check for the following: 

• 

loose or damaged equipment in the pre-installed main rack 

• 

dents, scratches, or other damage on all sides of each component 

• 

physical damage to iDEN RadioBlade or RAP antennas or connectors