WebGate Inc. WB106X-WG1K User Manual
WebEye B106
WebEye B106 User’s Guide
23
- Wait for: To wait for a certain signal.
- Wait for Prompt: To wait for prompt.
- Send: To send after described script.
- Send CR (Carriage Return): It has the same effect to press ‘Enter’ key in the script.
- Send User ID: To send the ID that is described in ‘User ID’ square.
- Send Password: To send the password that is described in ‘Password’ square.
- Delay: To delay for a certain seconds that is described the following square.
4) Dynamic IP registration service for ISDN and xDSL users
This page is to register WebEye on
dynamic IP registration server.
If WebEye is installed on a network of
dynamic IP address (floating IP
address), administrator should register
the WebEye on dynamic IP registration
server to give common users simple
connectivity. If not, no one can access
the WebEye through Web browser. It is because that no one knows IP address which one can access the
WebEye with.
To solve the problem, WebGate runs a server making a list of WebEyes that have dynamic IP addresses. On
the server, WebEye registers its information such as name, location, and description, so that common users
may detect a certain WebEye. Name, location and description are assigned at ‘System Configuration ’ page. If
administrator does not change them, the WebEye will register default information on the list, and it will be
very difficult to point out and access a certain WebEye. The list is on an Internet homepage of WebEye
very difficult to point out and access a certain WebEye. The list is on an Internet homepage of WebEye
(
www.webeye.to
).
(1) Auto IP Registration Function
Administrator may register one’s WebEye by enabling ‘Auto IP Registration Function’. Registration process
is that WebEye detects IP addresses from DHCP server and informs the detected IP addresses to dynamic IP
registration server.
(2) Registration Server Address
This is to configure a server address for registration. The registration server to be used for Dynamic IP
registration should be installed proper S/W, developed by WebGate Inc.
(3) Registration Interval
Dynamic IP address es are commonly used with xDSL, ISDN or Cable Modem lines. In order to maintain
continuous connectivity, user should reset the ‘Registration Interval’ at a shorter time interval than the default
continuous connectivity, user should reset the ‘Registration Interval’ at a shorter time interval than the default
value.
(4) Add Public List
There are two registration systems. One is to register on a public list and the other is on a private list.
(5) Access Token
Access token is a password and it is used when you register your own WebEye on a list ‘User’s WebEye’ out
of all WebEyes on WRS(WebEye Registration Server).