Schulte-Schlagbaum AG SOT01 User Manual

5.2. Configuring the SAFE-O-TRONIC with the "SetupKey"

The SetupKey is used to configure the System-ID, the cabinet number, the operating mode and
the group number in the SAFE-O-TRONIC . Only than can the SAFE-O-TRONIC be used in the
system.

An already configured SAFE-O-TRONIC will no longer accept the SetupKey. To change the con-
figuration of a SAFE-O-TRONIC , the latter must first have been cleared using a valid ResetKey.

1. Set the parameters on megalock Admin or on the megalock Programmer and program them

into the SetupKey.

Set the following data:
- Next SAFE-O-TRONIC number to be programmed (cabinet number)
- Operating mode (free cabinet select / fixed cabinet assignment / multi-user mode)
- Group No. to which the SAFE-O-TRONIC is to be assigned.

2. Go to the first SAFE-O-TRONIC with the SetupKey, waken up the lock and configure it by pre-

senting the SetupKey.

The SetupKey must be held in front of the rotary knob until the SAFE-O-TRONIC ac-
knowledges this by causing the green LED to flash.

3. Now the next SAFE-O-TRONIC can be configured with a sequential cabinet number.

Assigning the megalock number is done according to the same principle.

Once the SAFE-O-TRONIC

has uploaded

the number, it increments the number on the
SetupKey by +1.

Now the number for the next SAFE-O-
TRONIC is stored on the SetupKey, and as
many megalocks as desired can be initialized
with a sequential number without having to
first reprogram the SetupKey.