Radwin Ltd. 5XACMOD3C User Manual
FinM Deployment Guide
Release 4.5.10
4‐7
Project Tab
Configuring the Radio Network
ISU: Use the Indoor Synchronization Unit. Used in below ground
scenarios.
scenarios.
None: Do not use synchronization
Desired Tx Ratio
(downlink/uplink):
(downlink/uplink):
Symmetric (50/50): Use this if there is no significant difference
in the transmission conditions between TBS‐>TMU and TMU‐
>TBS.
in the transmission conditions between TBS‐>TMU and TMU‐
>TBS.
Max Uplink (20/80): Use this if your project requires the uplink
(TMU‐>TBS) to be much stronger than the downlink (TBS‐
>TMU).
(TMU‐>TBS) to be much stronger than the downlink (TBS‐
>TMU).
Uplink (30/70): Use this if your project requires the uplink (TMU‐
>TBS) to be stronger than the downlink (TBS‐>TMU).
>TBS) to be stronger than the downlink (TBS‐>TMU).
Downlink (70/30): Use this if your project requires the downlink
(TBS‐>TMU) to be stronger than the uplink (TMU‐>TBS).
(TBS‐>TMU) to be stronger than the uplink (TMU‐>TBS).
Max Downlink (80/20): Use this if your project requires the
downlink (TBS‐>TMU) to be much stronger than the uplink
(TMU‐>TBS).
downlink (TBS‐>TMU) to be much stronger than the uplink
(TMU‐>TBS).
Tx Power, HBS [dB]:
Maximum is typically 25 dB, minimum is 0. Set the value that
will give you the best throughput with the least noise.
will give you the best throughput with the least noise.
Tx Power, HMU [dB]:
Maximum is typically 25 dB, minimum is 0. Set the value that
will give you the best throughput with the least noise.
will give you the best throughput with the least noise.
Traps Filter On:
Enable this to filter the traps to those that are relevant for your
project. If this is not enabled, then every change or trap ‐ not
matter how trivial ‐ will be recorded, and your traps list will
quickly become very large and cumbersome.
project. If this is not enabled, then every change or trap ‐ not
matter how trivial ‐ will be recorded, and your traps list will
quickly become very large and cumbersome.
We recommend to enable this parameter.
VLAN Management:
Enable if your project is using a VLAN.
Adaptive Modulation
Mode:
Mode:
MIMO: (Multi‐In, Multi‐Out) Set the transmission method to use
one data stream, but multiple data signals. This is useful in a less
noisy environment that requires a higher capacity, but where
drops will not likely occur, such as when the train is stopped at a
station.
one data stream, but multiple data signals. This is useful in a less
noisy environment that requires a higher capacity, but where
drops will not likely occur, such as when the train is stopped at a
station.
Diversity: Set the transmission method to use more than one
data stream. This is useful when the train is travelling in a noisy
environment or when drops are likely to occur, such as during
fast movement.
data stream. This is useful when the train is travelling in a noisy
environment or when drops are likely to occur, such as during
fast movement.
Auto MIMO/Diversity: Set the system to automatically detect
the conditions to switch between MIMO and Diversity.
the conditions to switch between MIMO and Diversity.
Write Community:
Set the link password here.