Radwin Ltd. RW2030 User Manual
Default Settings
Chapter 4
RADWIN 1000/2000/5000 User ManualVersion 2.6.50p1
4-9
3. Site Configuration - described in chapter
6
.
Site specific configuration for each side of the link is available at any time
- under a running link or under the restricted Installation mode.
- under a running link or under the restricted Installation mode.
Site Configuration consists of a set of panels, which may be invoked indi-
vidually in any order, as needed.
vidually in any order, as needed.
Default Settings
The default settings of the RADWIN 1000/2000/5000 configuration parame-
ters are listed in
ters are listed in
below:
Front Panel LEDs on the IDU-C
The front panel LEDs on the IDU provide basic information about link sta-
tus.
tus.
Note
An installed and configured link can be returned to installation mode for re-
installation and configuration from last settings or from factory settings.
• Reversion to installation mode requires a complete break in the link
service
• Configuration mode may vary the service throughput and quality, but
without a service break
Table 4-3: Default Settings
Parameter
Default Value
ODU IP Address
10.0.0.120
Subnet Mask
255.0.0.0
Trap destination
0.0.0.0
Manager Login password
admin
Link ID
Link
Site 1
Site
Site 2
Site
Link Password
wireless-bridge
Rate
Adaptive
Ethernet Configuration
Auto Detect
Radio Link Failure Actions
No action
Bridge or Hub mode
Hub Mode, Aging time = 300 sec
Community values
Read-write – netman
Read-only – public
Read-only – public