Radwin Ltd. WINLINK User Manual

Chapter 2  Initial Setup 

AirMux-104 Installation and Operation Manual 

2-8 

Performing Initial Setup of AirMux-104

 

 

 

To assign IP addresses to the local and remote units: 
1.  In the Service Parameters dialog box, click Change IP Address. 

The IP Parameters dialog box appears (see 

2.  In the IP Parameters dialog box, select the First check box to configure the IP 

parameters of the first AirMux-104. 
or  
Select the Second check box to configure the IP parameters of the second 

AirMux-104. 

3.  In the IP Parameters dialog box, enter IP address, IP subnet mask, default 

gateway and trap destination values for the first and/or second unit. 

4. Click OK. 
5.  The Service Parameters dialog box appears (see 

6.  From the Service Parameters dialog box, click Next to proceed with the 

configuration download to the first unit. 

 

After completing system and service configuration, you must download new values 
to both AirMux-104 devices. 

 

To download configuration data: 
1.  Make sure that the management station is connected to the 10/100 LAN port 

of the RTCB, and click the Download button in the Download Data dialog box 
(see 

Downloading process to the first RT begins. Once the downloading to the 

first unit is completed, the upper Download button becomes dimmed. 

2.  Click the lower Download button to download configuration data to the 

second RT. 

After successfully completing software download to the second unit, 

AirMux-104 displays Installation Completed Successfully message (see