Radwin Ltd. WINLINK User Manual

 

 

 

 

To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cords. 

 

 

 

Pour réduire les risques s’incendie, utiliser seulement des conducteurs de 

télécommunications 26 AWG ou de section supérieure. 

 

Some ports are suitable for connection to intra-building or non-exposed wiring or cabling only. In such 

cases, a notice will be given in the installation instructions. 
Do not attempt to tamper with any carrier-provided equipment or connection hardware. 

The equipment is designed and approved to comply with the electromagnetic regulations of major 
regulatory bodies. The following instructions may enhance the performance of the equipment and will 

provide better protection against excessive emission and better immunity against disturbances. 
A good earth connection is essential. When installing the equipment in a rack, make sure to remove all 
traces of paint from the mounting points. Use suitable lock-washers and torque. If an external 

grounding lug is provided, connect it to the earth bus using braided wire as short as possible. 
The equipment is designed to comply with EMC requirements when connecting it with unshielded 

twisted pair (UTP) cables. However, the use of shielded wires is always recommended, especially for 
high-rate data. In some cases, when unshielded wires are used, ferrite cores should be installed on 

certain cables. In such cases, special instructions are provided in the manual. 
Disconnect all wires which are not in permanent use, such as cables used for one-time configuration. 
The compliance of the equipment with the regulations for conducted emission on the data lines is 

dependent on the cable quality. The emission is tested for UTP with 80 dB longitudinal conversion loss 

(LCL). 
Unless otherwise specified or described in the manual, TNV-1 and TNV-3 ports provide secondary 

protection against surges on the data lines. Primary protectors should be provided in the building 

installation. 
The equipment is designed to provide adequate protection against electro-static discharge (ESD). 
However, it is good working practice to use caution when connecting cables terminated with plastic 

connectors (without a grounded metal hood, such as flat cables) to sensitive data lines. Before 

connecting such cables, discharge yourself by touching earth ground or wear an ESD preventive wrist 
strap. 

This equipment has been tested and found to comply with the limits of the Class A digital device, 
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection 

against harmful interference when the equipment is operated in a commercial environment. This 

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in 

accordance with the Installation and Operation manual, may cause harmful interference to the radio 
communications. Operation of this equipment in a residential area is likely to cause harmful 

interference in which case the user will be required to correct the interference at his own expense. 
Changes or modifications to this equipment not expressly approved by the party responsible for 
compliance (RAD) could void the user’s authority to operate the equipment.