Radwin Ltd. WL1000F49 User Manual
Chapter 2 Installation and Setup
WinLink 1000 Installation and Operation Manual
2-6
Installation and Setup
2. Connect the ODU cable to the RJ-45 connector on the IDU panel
designated WAN.
illustrates a typical panel of the IDU-E
and IDU-C.
Figure 2-2. IDUs connector panels
Other models may have a different configuration for these panels.
Connecting the Power
Before connecting any cable, the protective earth terminals of the
AC/DC power must be connected to the protective ground conductor
of the mains power cord. (Applies to both IDU models.) If you are using
an extension cord (power cable) make sure it is grounded as well.
Any interruption of the protective (grounding) conductor (inside or
outside the instrument) or disconnecting of the protective earth
terminal can make this unit dangerous. Intentional interruption is
prohibited.
AC/DC power must be connected to the protective ground conductor
of the mains power cord. (Applies to both IDU models.) If you are using
an extension cord (power cable) make sure it is grounded as well.
Any interruption of the protective (grounding) conductor (inside or
outside the instrument) or disconnecting of the protective earth
terminal can make this unit dangerous. Intentional interruption is
prohibited.
Power is supplied to WinLink 1000 via an external AC/DC converter,
which receives power from 110–240 VAC source and converts it to
-24VDC or -48 VDC.
which receives power from 110–240 VAC source and converts it to
-24VDC or -48 VDC.
Warning
Note