The Watt Stopper Inc. TDWALL User Manual

How to install and use the
wireless Miro

TM

remote switch

(MRD8)

English

Read and retain these instructions

Français

Español

Ready?

Application

For more

information

on designing,

installing and using

wireless Miro

TM

systems, and for expert

technical

help

, visit our web site at

www.passandseymour.com/miro

Use one or more wireless Miro

TM

remote

switches in a group with a wireless Miro

TM

dimming or switching device, for seamless 3-

way, 4-way (or more-way!) control of a load

circuit from multiple locations.

The wireless Miro

TM

remote switch may be

combined with the following wireless Miro

TM

control devices:

Incandescent Dimmer

Universal Dimmer

Non-dim Switch

Plug-in Lamp Module

Plug-in Appliance Module

Installation

Disconnect power to circuit by turning circuit

breaker OFF before installation.

Remove existing wall plate and switch.

Strip existing wires ½”

Wire the LIVE (black), NEUT (white), and

GND supply wires to the correspondingly

marked screw terminals, following the

wiring diagram in figure 1

Mount using a Miro

TM

wall plate, following

instructions provided

Switch the circuit breaker back ON.

INSTALL IN COMPLIANCE WITH ALL

APPLICABLE CODES & STANDARDS.

Failure to follow these instructions may

cause personal injury or equipment damage.

Get Set…

Configuration

Figure 2

To prevent interference between neighboring

systems, wireless Miro

TM

devices must

acquire a unique house ID before use. It’s

simple!

1. With all devices installed and energized,

check that every wireless Miro

TM

device

is showing a yellow LED. If not, check

that the circuit breaker is on and that the

device is correctly installed.

2. All devices in a home must be ‘bound’ to

the same home ID. For a new wireless

Miro

TM

installation, simultaneously press

and hold the top and bottom (Ú) of any

device paddle for 2 seconds. Its LED

flashes yellow, indicating that it has

acquired a unique House ID.

3. Check that all other wireless Miro

TM

device LEDs are flashing green,

indicating that they have acquired the

same House ID.

4. Return to the first device, and press Ú

again for 2 seconds. All device LEDs

revert to green, indicating that house

binding is complete.

Note: if you’re adding the device to an

existing wireless Miro

TM

installation, simply

press and hold Ú on any previously bound

device for 2 seconds to start the procedure,

verify that the newly added device LED is

flashing green, indicating that it has acquired

the House ID. Press and hold Ú for 2

seconds again on the same previously

installed device to terminate.

GND

NEUT

LIVE

Figure 1

Supply

Wire

2, 4

3

3

3

Ø

×

When you see Ú in

the instructions,

press and hold the

top and the bottom

of the device face
for 2 seconds