Canfield Industries Inc. RVIH1 User Manual

Rvibrake Installation Instructions

Thank you for choosing Rvibrake as your auxiliary braking system!
We are dedicated to making your towing experience as safe as
possible by providing the most effective portable braking system
available.

Use of the Rvibrake or any of its accessories in a manner that is

inconsistent with these Instructions could cause damage to the

motorhome or towed vehicle and may cause injury or even death.
Please read and understand these instructions before using this product.

Please contact us at 1-800-815-2159 if you have any questions.

Step 1)  Remove the Rvibrake, Breakaway System and Wireless Monitor
             from the shipping carton and inspect them for any shipping

damage . If you see any damage please notify us immediately.

(Fig. 1)

Step 2) Adjust the driver’s seat to the far back position and place the

Rvibrake on the floorboard so that the Clevis is directly in front
of the brake pedal of the towed vehicle. Carpeted floor mats do

not need to be removed but thicker rubber mats should be

removed prior to using the Rvibrake.

Step 3) Attach the Clevis onto the Brake Pedal of the towed vehicle so

that the lower part of the Clevis grabs the bottom of the brake

pedal first, and then extend the upper part of the Clevis over

the top of the brake pedal. (Fig. 2)

Step 4) Slide the Rvibrake back towards the seat until the Rvibrake

hits against the edge of the seat pan. (The seat pan is the slightly

elevated area of the floorboard that the driver’s seat is mounted

on.) If your vehicle has a flat floorboard and no seat pan to push

against, please refer to the Stop Plate Installation guide inside of

Stop Plate package. (Fig. 3)

Step 5) Plug the Rvibrake 12 volt adapter into the 12 volt receptacle of

the towed vehicle. The air compressor will start to run and the Red

LEDs on the control panel of the Rvibrake will start to flash. (Fig. 4)

(Fig. 1)

(Fig. 2)

(Fig. 3)

(Fig. 4)