Canfield Industries Inc. RVIH1 Manual De Usuario
Rvibrake Installation Instructions
Thank you for choosing Rvibrake as your auxiliary braking system!
We are dedicated to making your towing experience as safe as
possible by providing the most effective portable braking system
available.
We are dedicated to making your towing experience as safe as
possible by providing the most effective portable braking system
available.
Use of the Rvibrake or any of its accessories in a manner that is
inconsistent with these Instructions could cause damage to the
motorhome or towed vehicle and may cause injury or even death.
Please read and understand these instructions before using this product.
Please read and understand these instructions before using this product.
Please contact us at 1-800-815-2159 if you have any questions.
Step 1) Remove the Rvibrake, Breakaway System and Wireless Monitor
from the shipping carton and inspect them for any shipping
Step 1) Remove the Rvibrake, Breakaway System and Wireless Monitor
from the shipping carton and inspect them for any shipping
damage . If you see any damage please notify us immediately.
(Fig. 1)
Step 2) Adjust the driver’s seat to the far back position and place the
Rvibrake on the floorboard so that the Clevis is directly in front
of the brake pedal of the towed vehicle. Carpeted floor mats do
of the brake pedal of the towed vehicle. Carpeted floor mats do
not need to be removed but thicker rubber mats should be
removed prior to using the Rvibrake.
Step 3) Attach the Clevis onto the Brake Pedal of the towed vehicle so
that the lower part of the Clevis grabs the bottom of the brake
pedal first, and then extend the upper part of the Clevis over
the top of the brake pedal. (Fig. 2)
Step 4) Slide the Rvibrake back towards the seat until the Rvibrake
hits against the edge of the seat pan. (The seat pan is the slightly
elevated area of the floorboard that the driver’s seat is mounted
on.) If your vehicle has a flat floorboard and no seat pan to push
against, please refer to the Stop Plate Installation guide inside of
Stop Plate package. (Fig. 3)
Step 5) Plug the Rvibrake 12 volt adapter into the 12 volt receptacle of
the towed vehicle. The air compressor will start to run and the Red
LEDs on the control panel of the Rvibrake will start to flash. (Fig. 4)
(Fig. 1)
(Fig. 2)
(Fig. 3)
(Fig. 4)