Tagsys S.A. LSP3CLEAR-L40 User Manual
December 2009
Revision 2.1
19/68
4 Installation
4.1 Recommendations before Installation
4.1.1 Wire Feed Sheaths
Within the framework installation you need at least a power supply cable sheath and an
Ethernet cable sheath to connect to the Ethernet network. These sheathed cables will be located at
the bottom center of the pedestal as shown in
the bottom center of the pedestal as shown in
Figure 10
.
If needed according to the installation configuration, extra sheathed cables need to placed
for wire synchronization, Trigger cable and to remotely switch the RF on & off and I/O cables to
drive external devices (Camera, Remote alarms…).
drive external devices (Camera, Remote alarms…).
The L-SP3 is delivered without any IEC terminated plug power supply cable or Telecommunication
cable. It is up to the Local installation personnel to use the appropriate IEC Power Cord according
to local electrical regulations.
cable. It is up to the Local installation personnel to use the appropriate IEC Power Cord according
to local electrical regulations.
Use appropriate IEC power cord according to the local regulations to
power up and interconnect the pedestals.
power up and interconnect the pedestals.
The Power Supply Cord is the LSP3 Product Main Disconnecting Device,
It should be easily accessible at any time to Disconnect the pedestals
from the mains power supply.
It should be easily accessible at any time to Disconnect the pedestals
from the mains power supply.